Art.-No.: KMS-RF-B, KMS-RF-W • Datasheet KMS-RF

The MultiSensor-RF is operated in conjunction with an AlarmManager. The recorded sensor data is sent via radio (ZigBee®) to the AlarmManager and evaluated. In addition, the MultiSensor-RF has a built-in and maintenance-free buffering of the voltage for approx. 3 minutes. This also enables the detection of power failures and sabotage.

MultiSensor-RF Front

MultiSensor-RF Back

  1. This button is used to teach the device into the wireless network. To teach-in the sensor, start the teach-in process in the web interface of the AlarmManager and then press the teach-in button for 3 seconds until a signal tone is heard
  2. Mounting bracket: To remove, lift the bracket and pull the bracket towards the bracket

MultiSensor-RF Connections


  1. Kentix Systemport: For connection to power supply (only possible with enclosed KIO2-Adapter and power supply unit)

The Multi-Sensor RF is NOT powered by POE. To connect the Multi-Sensor-RF, the enclosed KIO2-Adapter and a power supply is necessary.

Connection Example


  1. Plug-in power supply (100-230VAC/24VDC)
  2. Standard patch cable (delivered with 5m SlimLine), extension up to 25m possible

The MultiSensor-RF is configured via the AlarmManager. It is not possible or necessary to install updates.

Einlernvorgang
  1. To add a MultiSensor RF to the AlarmManager configuration, select + in the Alarm Zone Heading area of the dashboard, then select MultiSensor (Radio)
  2. Press the teach-in button for 3 seconds, which you reach via the recess on the back of the housing
  3. The sensor should be detected within 15-20 seconds. The configuration mask for the sensor is then opened directly. The teach-in process is now complete
  4. Make the individual settings for the configuration of the sensor and finally save the settings